Operating A Computer Using The Remote Control; Placement - Toshiba TLP-X200U Owner's Manual

Operating a computer using the remote control

A computer can be operated using the projector's remote control. This function is available on
any computer with the Windows ® 98/98SE, Windows
Windows Vista operating system, that is equipped with a USB port which can support USB
®
.0 (The mouse remote control receiver is also supported on Mac OS 9 and Mac OS X for
the Macintosh). However, please note that Toshiba does not guarantee the operation of all
computers.
Connecting a computer
1
Connect the mouse remote control receiver (supplied) to a computer.
To USB port
Mouse remote control receiver
Operating a computer
2
Operate remote control's buttons towards the mouse remote control receiver.
Moving the mouse pointer

Press the mouse control button in the direction you wish the mouse pointer to move.
To left click

Press the L-CLICK button.
To right click

Press the R-CLICK button.
To drag and drop

Holding down the L-CLICK button, move the mouse control button until the mouse
pointer is over the desired location, then release the L-CLICK button.
Using the computer's page up [ ↑ ] and down [ ↓ ] function

Press the PAGE+ and PAGE- buttons to switch PowerPoint
Remote Control Top Remote Control Underside
Mouse control
PAGE –
® Me, Windows ® 000, Windows ® XP, or
The remote control may fail to operate
if the mouse remote control receiver
is exposed to bright sunlight or
fluorescent lighting.
In such a case, change position or
direction of the mouse remote control
receiver and retry.
slides.
®
R-CLICK
L-CLICK
PAGE +
0

Placement

Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is "floor-mounted front projection." Set the [Projection mode] in the
Default setting 2 menu , in accordance with your needs.
p.43
Floor-mounted front projection
Floor-mounted rear projection
Ceiling-mounted front projection
Ceiling-mounted rear projection
WARNING
• Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS
when placing the unit. Attempting to clean and replace the lamp in a high location
by yourself may cause you to fall, resulting in injury.
If you wish to mount the projector on the ceiling, be sure to ask your dealer
•
to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold
separately) and specialized knowledge. Improper mounting could cause the projector
to fall, resulting in possible injury and unit damage.
• If the projector is ceiling-mounted, install the breaker for turning off the power in
case of anomaly. Let everyone involved with the use of the projector know that fact.
1