Declaration Of Conformity For Wireless Vehicle Components; Diagnostics Connection - Mercedes-Benz AMG GT Roadster Operator's Manual

Remove trapped plants or other flam‐
#
mable material.
If there is damage, consult a qualified
#
specialist workshop immediately.
* NOTE Damage to the vehicle
In the following situations, in particular, there
is a risk of damage to the vehicle:
The vehicle becomes grounded, e.g. on a
R
high curb or an unpaved road
The vehicle is driven too fast over an
R
obstacle, e.g. a curb, speed bump or pot‐
hole
A heavy object strikes the underbody or
R
chassis components
In situations such as this, the body, the
underbody, chassis components, wheels or
tires could be damaged without the damage
being visible. Components damaged in this
way can unexpectedly fail or, in the case of
an accident, may not absorb the loads that
arise as intended.
If the underbody paneling is damaged, flam‐
mable materials such as leaves, grass or
twigs can collect between the underbody and
the underbody paneling. These materials may
ignite if they come into contact with hot
parts on the exhaust system.
Have the vehicle checked and repaired
#
immediately at a qualified specialist
workshop.
or
If driving safety is impaired while con‐
#
tinuing your journey, pull over and stop
the vehicle immediately in accordance
with the traffic conditions, and contact
a qualified specialist workshop.
Declaration of conformity for wireless vehi‐
cle components
USA: "The wireless devices of this vehicle com‐
ply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) These
devices may not cause harmful interference, and
2) These devices must accept any interference
General notes
received, including interference that may cause
undesired operation. Changes or modifications
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment."
Canada: "The wireless devices of this vehicle
comply with the Industry Canada license-exempt
RSS standard(s). Operation is subject to the fol‐
lowing two conditions: (1) These devices may
not cause interference, and (2) These devices
must accept any interference, including interfer‐
ence that may cause undesired operation of the
device."

Diagnostics connection

The diagnostics connection is only intended for
the connection of diagnostic devices at a quali‐
fied specialist workshop.
23