Mercedes-Benz AMG GT Roadster Operator's Manual page 337

Hide thumbs Also See for AMG GT Roadster:
Table of Contents

Advertisement

%
The values displayed in the multifunction dis‐
play may deviate from those of the tire pres‐
sure gauge as they refer to sea level. At high
altitudes, the tire pressure value indicated by
a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tire pressure.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
page 329)
/
R
Restarting the tire pressure monitoring sys‐
tem
Requirements:
The recommended tire pressure is correctly
R
set for the respective operating status on
each of the four wheels (
page 329).
/
Restart the tire pressure monitoring system in
the following situations:
The tire pressure has changed.
R
The wheels or tires have been changed or
R
newly installed.
On-board computer:
Service
Tires
4
5
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The
Use Current Pressures as New Refer-
ence Values?
message is shown in the multi‐
function display.
To begin restart, press Touch Control on the
#
left-hand side of the steering wheel.
The
Tire Press. Monitor Restarted
shown in the multifunction display.
Current warning messages are deleted and
the yellow h warning lamp goes out.
After you have been driving for a few
minutes, the system checks whether the cur‐
rent tire pressures are within the specified
range. The current tire pressures are then
accepted as reference values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
page 329)
/
R
Radio-equipment approval of the tire pres‐
sure monitoring system
Radio equipment approval numbers
Country
Radio type approval number
Canada
IC: 2546A-GG4T
IC: 2546A-DG6W2D4
IC: 2546A-MC34MA4
Le présent appareil est conforme
message is
aux CNR d'Industrie Canada
applicables aux appareils radio
exempts de licence. L'exploita‐
tion est autorisée aux deux con‐
ditions suivantes:
(1) l'appareil ne doit pas produire
de brouillage, et
(2) l'utilisateur de l'appareil doit
accepter tout brouillage radioé‐
lectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.
Wheels and tires 335

Advertisement

Table of Contents
loading

Table of Contents