Advertisement
• Use a Phillips Head
screwdriver to remove the
front cover.
• Press and hold down the
Connect button on the PCB
until the LED double flashes
every second.
• Release the button.
• If paired successfully, the
module LED will return to the
previous color.
IMPORTANT
When a push button or motion sensor is activated, the
pump turns on and runs for five minutes or until the
selected water temperature is reached (whichever occurs
first). The pump turns off and enters into a dormant
(inactive) state according to the parameter settings/dip
switches selected in the water heater. During this time, the
pump will not turn on for any reason, even if the push
button or motion sensor is activated.
Refer to the tankless water heater installation and
operation manual for more information on Circ-Logic
(Rinnai's recirculation technology) and recirculation
parameter/dip switch settings.
Advertisement
