Advertisement
❸
Route the module controller cable through the grommet
(located on the bottom, right side of the unit) and connect to
the mating terminal on the bottom, right side of the PC
Board.
MODULE
Controller
Cable
Important: If your module wires include spade end
connectors, follow the steps below:
• Cut the spade end
connectors off the two
module wires. Then,
strip the insulation off
both ends.
• Connect the module
cable to the SENSEI™
controller cable
(included in water heater
packaging or sold
separately) using wire
nuts or other approved
wire connectors.
PC
Board
Mating
Terminal
MODULE
MODULE
Grommet
Under Unit
Strip
insulation
Wire
Nuts
Controller
Cable
Advertisement
