Connecting An Hdmi Or A Dvi Device To The Hdmi Input - Toshiba 32HLX95 Owner's Manual

Connecting an HDMI
[1]
The HDMI input on your TV receives digital audio and
uncompressed digital video from an HDMI device or
uncompressed digital video from a DVI
This input is designed to accept HDCP
digital form from EIA/CEA-861/861B–compliant
electronic devices (such as a set-top box or DVD player with
HDMI or DVI output).
The HDMI input is designed for best performance with 720p
signals but it will also accept and display 1080i, 480i, and 480p
signals.
NOTE: DO NOT CONNECT A PC USING
THE HDMI PORT.
ALWAYS use the VGA port provided to connect a PC.
To connect an HDMI device, you will need:
• one HDMI cable (type A connector) per HDMI device
For proper operation, it is recommended that you use as
short an HDMI cable as possible. You should not
encounter difficulty if you use an HDMI cable shorter
than 16.4 ft. (5m).
HDMI cable transfers both video and audio. Separate analog
audio cables are not required (see illustration below). Some
CDVs (video CDs) may not output digital audio signals. In
that case, you may hear sound by connecting analog audio
cables.
See "Setting the HDMI audio mode" on page 43.
HDMI device
VIDEO AUDIO
L R IN
OUT
L R
TV lower back panel
___________
HDMI, the HDMI logo and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing LLC.
Chapter 2: Connecting your TV
™
or a DVI device to the HDMI input
[2] device.
[3]
program material in
[4]
consumer
HDMI OUT
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
__________________________________________________________________
[1]
HDMI = High-Definition Multimedia Interface.
[2]
DVI = Digital Video Interface.
[3]
HDCP = High-bandwidth Digital Content Protection.
[4]
EIA/CEA-861/861B compliance covers the transmission of
uncompressed digital video with high-bandwidth digital content
protection, which is being standardized for reception of high-definition
video signals. Because this is an evolving technology, it is possible that
some devices may not operate properly with the TV.
Note: To ensure that the HDMI or DVI device is reset
properly, it is recommended that you follow these
procedures:
• When turning on your electronic components, turn on
the TV first, and then the HDMI or DVI device.
• When turning off your electronic components, turn off
the HDMI or DVI device first, and then the TV.
To connect a DVI device, you will need:
• one HDMI-to-DVI adapter cable (HDMI type A
connector) per DVI device
For proper operation, the length of an HDMI-to-DVI adapter
cable should not exceed 9.8 ft (3m). The recommended length
is 6.6 ft (2m).
• one pair of standard analog audio cables per DVI
device
An HDMI-to-DVI adapter cable transfers video only.
Separate analog audio cables are required (see
illustration below).
See "Setting the HDMI audio mode" on page 43.
DVI device
VIDEO AUDIO
L R IN
OUT
L R
R
DVI/HDCP
OUT
TV lower back panel
21