Selecting The Cinema Mode (480I Signals Only); Selecting The Lamp Mode - Toshiba TheaterWide 62HM15 Owner's Manual

Selecting the cinema mode
(480i signals only)
When you view a DVD (480i signal; 3:2 pulldown processed)
from a DVD player connected to the ColorStream HD1/HD2
(component video) or HDMI inputs on the TV, smoother
motion can be obtained by setting the CINEMA MODE to
FILM.
To set the CINEMA MODE to FILM:
1. Press MENU and open the VIDEO menu.
2. Highlight THEATER SETTINGS and press ENTER.
Video
Picture Settings
Theater Settings
Advanced Picture Settings
DVD RTN
Navigate Select Back
CH RTN
3. In the CINEMA MODE field, select FILM.
4. To save your settings temporarily, highlight DONE and
press ENTER.
To save your settings permanently, highlight SAVE and
press ENTER.
To set the CINEMA MODE to VIDEO:
Select VIDEO in step 3 above.
72
#01E066-075_62HM15 72
Black
62HM15
Chapter 8: Using the TV's features
Exit
EXIT
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Selecting the lamp mode

You can select either the HI BRIGHT or LOW POWER lamp
mode.
• The HI BRIGHT mode is useful when additional picture
brightness is desired (such as in a bright room).
• The LOW POWER mode reduces wear on the projection
lamp. Using this mode should result in longer lamp life.
See "Lamp unit replacement" on page 98–100.
To select the lamp mode:
1. Press MENU and open the VIDEO menu.
2. Highlight THEATER SETTINGS and press ENTER.
Video
Picture Settings
Theater Settings
Advanced Picture Settings
DVD RTN
Navigate Select Back Exit
EXIT
CH RTN
3. In the LAMP MODE field, select HI BRIGHT or LOW
POWER, whichever you prefer.
4. To save your settings temporarily, highlight DONE and
press ENTER.
To save your settings permanently, highlight SAVE and
press ENTER.
5/24/05, 6:20 PM