Selecting The Cinema Mode (480I Signals Only); Selecting The Lamp Mode - Toshiba 56MX195 Owner's Manual

Selecting the cinema mode
(480i signals only)
When you view a DVD (480i signal; 3:2 pulldown processed)
from a DVD player connected to the VIDEO 1, VIDEO 2,
ColorStream HD1/HD2 (component video), or HDMI inputs
on the TV, smoother motion can be obtained by setting the
Cinema Mode to Film.
To set the Cinema Mode to Film:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
Navigate Back
Select CH RTN EXIT
3. In the Cinema Mode field, select Film.
Theater Settings
Picture Size
Picture Scroll -1
Cinema Mode
Auto Aspect Ratio
Reset Done
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
To set the Cinema Mode to Video:
Select Video in step 3 above.
80
Chapter 8: Using the TV's features
Exit
Natural
Film
On
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Selecting the lamp mode

You can select either the High Bright or Low Power lamp mode.
• The High Bright mode is useful when additional picture
brightness is desired (such as in a bright room).
• The Low Power mode reduces wear on the projection lamp.
Using this mode should result in longer lamp life.
See "Lamp unit replacement and care" on page 128–130.
To select the lamp mode:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
Navigate Select CH RTN Back EXIT
3. In the Lamp Mode field, select High Bright or Low Power,
whichever you prefer.
Advanced Picture Settings
Dynamic Contrast
MPEG Noise Reduction
CableClear
Color Temperature
Lamp Mode
Reset
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note:
If you set the lamp mode to Low Power, each time you turn on the TV, the
lamp will start out in High Bright mode but will switch to Low Power mode
in approximately 1 minute. You will notice a change in screen brightness
when this happens. This is normal and is not a sign of malfunction.
Exit
ANT 1
On
Low
Auto
Cool
Low Power
Done