Jackson TEMPSTAR Series Installation, Operation & Service Manual page 19

4
Connect pressure gauge with a 9/16 wrench. Connect the two hoses using an adustable wrench.
The hoses are cut to length and will only reach their intended connection point.
A. Connect the Gauge
C. PRV Inlet from Coil
Before moving to the next step, tidy up the hoses by sliding them under the clamps. You may need to
loosen the nut to accomplish this.
VENTLESS HEAT RECOVERY MOUNTING INSTRUCTIONS
B. Final Rinse Inlet
D. Booster Outlet
13
INSTALLATION & OPERATION