Searching And Sampling The Code Of A Device (8500); Using The Volume Lock Feature (8000); Operational Feature Reset (8900) - Toshiba REGZA 46SV670U Owner's Manual

Searching and sampling the code of
a device (8500)
If you do not know the device code for a particular
device, you can cycle the remote control through the
available codes for that device mode and sample the
functions to find the code that operates the target
device. The keys available to be sampled, provided they
are applicable to that mode, are p, 1, z, <, and S.
Invalid keys will be ignored while in program mode.
To cycle through each available device code and sample
its functions:
1
Press the appropriate mode select button on the
remote control.
While holding down E, press 8, 5, 0, 0. The remote
2
control will enter program mode.
3
Point the remote control at the target device and
press p (or other function buttons that are
available to be sampled).
4
If the device responds to the remote control:
Press E to store the device code. The mode select button
will blink two times, and the remote control will exit the
program mode.
If the device does not respond to the remote control:
Press B, and then press p. Repeat this step until the
device responds to the remote control, and then press E.
Note: When a search cycle is completed, the mode
select button will blink three times. The remote control
will begin to cycle through the available codes again.
If no key is pressed within 10 seconds during
programming, the remote control will exit the program
mode and return to the previous code.
Chapter 3: Using the remote control
Using the volume lock feature
(8000)
By default (factory setting), the remote control's volume
keys (z, Z and W) are locked to the "TV" device
mode.
The remote control will operate the TV's volume, even
when "TV" is not the current device mode.
If you unlock the remote control's volume keys, each
device mode will have its own volume (if the device ID
has volume data). The remote control will operate the
volume of the device associated with the current device
mode.
If you lock the remote control's volume keys to a
specific device mode, the remote control will operate
the volume of the device associated with the locked
mode, even when the locked mode is not the current
device mode.
See "Using the remote control to operate your other
devices" on page 24.
To lock the remote control's volume keys to a specific
mode (CABLE/SAT in this example):
1
2
3
To unlock the remote control's volume keys:
1
2

Operational feature reset (8900)

This feature clears all programmed remote control
features not related to "Device code setup" and resets
the volume lock to the "TV" device mode.
To reset the remote control:
While holding down E, press 8, 9, 0, 0. The mode select
button will respond with four blinks.
Press CABLE/SAT.
While holding down the E button, press 8, 0, 0, 0.
Press z. The CABLE/SAT mode select button will
blink two times (locked).
The remote control's volume keys will now operate the
volume of the device associated with the CABLE/SAT
mode, even when CABLE/SAT is not the current device
mode.
While holding down E, press 8, 0, 0, 0.
Press Z. The CABLE/SAT mode select button will
blink four times.
The CABLE/SAT mode will be unlocked.
25