Performing A Media Check On A Raid-1 Array - Toshiba S3 User Manual

❖
❖
❖
❖
❖
❖

Performing a media check on a RAID-1 array

A media check compares the data of the mirrored hard drives
in an array to determine if there are any errors. If an error is
detected during a media check, the data will be restored on
the secondary internal hard disk based on the data on the
primary internal hard disk.
TOSHIBA RAID Console Utility
Status—Displays the status of the physical drive.
❖
Online—The drives are working in a normal state.
❖
Offline—The drive is not used, as it is not
configured as the logical drive.
❖
Fail—The drive is disabled, as a failure has occurred
on the drive.
❖
Locked—The drive is locked by password.
❖
Rebuilding—The drive is being rebuilt using data
from the good drive.
❖
Absent—The drive may have been removed from
the computer.
Capacity—Displays the drive capacity in gigabytes.
Model number—Displays the drive model number.
Serial number—Displays the drive serial number.
Firmware revision—Displays the drive firmware
revision.
S.M.A.R.T.—Displays the state of S.M.A.R.T.
❖
Normal—S.M.A.R.T. is within specifications.
❖
Warning—The threshold value of S.M.A.R.T. has
been exceeded.
Using the RAID-1 Utility
247