Using Standby - Toshiba S3 User Manual

128
Learning the Basics
Powering down the computer
❖
❖
5 Click Apply.
6 Click OK.
The computer is now set to automatically go into
Hibernation when your option settings occur.
NOTE
Once the computer is configured, put the computer into
Hibernation mode by either pressing the power button or
closing the display panel, depending on the hibernation
options taken.
Starting again from Hibernation mode
To start up the computer from Hibernation mode, press the
power button until the on/off light turns green. The computer
returns to the screen you were using.
If you put the computer in Hibernation mode by closing the
display panel, you can start it again by opening the display
panel.

Using Standby

The Standby command puts the computer into a power-
saving mode. Standby holds the current mode of the
computer in memory so that, when you restart the computer,
you can continue working from where you left off.
When I press the power button
Set this option to Hibernate so that the computer will go
into Hibernation mode when you press the power button.
When I close the lid
Set this option to Hibernate so that the computer will go
into Hibernation mode when you close the display panel.
For more information about the Power Saver utility, see
"TOSHIBA Power Saver" on page 178.