IBM MM75 Manual page 24

USMM75Bk.book : Emm75bod.fm Page 19 Friday, September 12, 1997 7:30 PM
Problem Possible Cause
Current program
does not use sound
Volume set too low
The sound may be
muted
No Sound
No audio signal from
the computer
Faulty audio system
in the computer.
Sound seems
Volume set too high
distorted
Sound from only Incorrect balance
one speaker setting
The Aptiva sound
No sound
system is not in use
symbols in the
OSD
The monitor is not attached to an Aptiva L or S series computer.
Sound controls Computer is running an application which is not supported by
not working the Aptiva Sound System, such as a DOS program.
Sound coming
from speakers
Audio program is still running in the computer
after monitor has
been switched off
Suggested Action
None.
Increase the volume using the rotary
volume control or OSD.
Press button 5 once or adjust the rotary
volume control.
If the sound was muted via a software
program, you must use this again to
restore sound.
Check the audio cables have been
properly connected to the computer.
Have the computer audio system checked
out.
Decrease volume using the volume rotary
control.
Adjust using OSD balance control.
Activate the Aptiva sound system program
Reference
User Controls
See on
page 8
Connecting
See
your monitor
on page
7
User Controls
See on
page 8
See your Computer
System Documentation
19