Assembly - Poulan Pro PPB4014 Instruction Manual

PACKING LIST
• Chainsaw
• Scabbard
• 2Ah Battery (PPB402AH)
• Battery Charger (PPB40CGR)
• Owner's Manual
If any parts are damaged or missing, please
call 1-855-378-6903.
WARNING:
If any parts are damaged or missing, do
not operate this product until the parts are
replaced. Failure to heed this warning could
result in serious personal injury.
Do not attempt to modify this product or
create accessories not recommended for
use with this product. Any such alteration or
modification is misuse and could result in
a hazardous condition leading to possible
serious personal injury. Do not install the
battery until assembly is complete. Failure to
comply could result in accidental starting and
possible serious personal injury.
BATTERY REMOVAL
1. Press the battery release button on the
chainsaw. This will cause the battery to
raise out of the tool.
2. Grasp the chainsaw firmly and pull the
battery out of the handle.
BATTERY INSTALLATION
1. Align the battery with the battery
opening.
2. Insert the battery into the battery
opening until the battery release button
locks into place.
3. Push down on the battery until it locks
into place. You should hear a "click"
once it is installed.
WARNING:
in order to avoid injury and to reduce the risk
of electric shock or fire:
• Replace the battery or the charger
immediately if the battery case or charger
cord is damaged.
• Verify that the switch is in the OFF position
before inserting or removing the battery
pack.
• Verify that the battery is removed and
the switch is in the OFF position before
inspecting, adjusting, or performing
maintenance on any part of the chainsaw.

ASSEMBLY

Follow these instructions
• Read, understand, and follow the
instructions contained in the charger
manual.
IMPORTANT:
charged when it is purchased. Before using
the chainsaw for the first time, place the
battery in the battery charger and charge.
Make sure to read all safety precautions
and follow the instructions in the battery and
charger manuals.
IMPORTANT:
equipped with an internal circuit breaker
which will automatically shut off the power
to the tool and then reset itself once cooled.
Follow these steps if an overload occurs while
under heavy use:
• Release the trigger. Restart tool by
pressing safety lock-out button and
depressing trigger.
• Under some conditions, the battery may
need to be removed for approximately 1
minute. This allows it to be cooled, reinstall
for use.
ADDING BAR AND CHAIN LUBRICANT
Use a bar and chain lubricant (not included)
with this product. It is designed for chains and
chain oilers, and is formulated to perform over
a wide temperature range with no dilution
required.
• Remove oil cap.
• Carefully pour the bar and chain oil into
the tank.
• Wipe off excess oil. Replace oil cap.
• Check and fill the oil tank when quick view
oil indicator is below the second to last
indicator line.
• Repeat as needed.
9
The battery may not be
This lithium-ion battery is