Advertisement
ST43401N/ND and ST43402ND Reference Manual, Rev. C
• Do not remove any circuit boards from the drive chassis. Return the entire
drive for depot repair if any circuit board is defective. Removal of circuit
boards by personnel not performing depot repair will damage components
and may void the warranty.
• Do not remove the head and disc assembly (HDA) from the drive chassis.
Return the entire drive for depot repair if the HDA is defective.
• Do not attempt to disassemble the HDA. It is not field repairable. If the sealed
HDA is opened by personnel not performing depot repair, this will damage
components and void the warranty.
• As a component, this drive is designed to be installed and operated in
accordance with UL1950, IEC950, EN60950, CSA C22.2 950, and VDE0805.
Refer to Section 2 for information about installation.
• Ensure that the power supply meets the specifications in this manual and
is designed to be used in accordance with UL1950, IEC950, EN60950, CSA
C22.2 950, and VDE0805.
Seagate takes all reasonable steps to ensure that its products are certifiable
to currently accepted standards. Typical applications of these disc drives
include customer packaging and subsystem design. Safety agencies condi-
tionally certify component assemblies, such as the Elite disc drive, based on
their final acceptability in the end-use product. The subsystem designers are
responsible for meeting these conditions of acceptability in obtaining safety/
regulatory agency compliance in their end-use products and in certifying
where required by law. A necessary part of meeting safety requirements is the
provision for overcurrent protection on drive SELV supply voltages.
This unit is a component part and as such is not meant to comply with FCC
or similar national requirements as a stand-alone unit. Engineering radiated
and conducted emissions test results are available through the Seagate
Safety Department to assist the subsystem designer.
v
Advertisement
