Related Manuals for Seagate ST500VM000
Summary of Contents for Seagate ST500VM000
- Page 1 Video 3.5 HDD SATA Product Manual ST1000VM002 ST500VM000 100780435, Rev. B October 2015...
- Page 2 Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners.
-
Page 3: Table Of Contents
Seagate® Technology Support Services ........ - Page 4 Mounting dimensions (1TB and 500GB models) ..........21 Seagate Video 3.5 HDD Product Manual, Rev. B...
-
Page 5: Seagate Technology Support Services
For information regarding online support and services, visit http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit http://www.seagate.com/services-software/seagate-recovery- services/recover/ For Seagate OEM, Distribution partner portal and reseller portal, visit: http://www.seagate.com/partners/ Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 6: Introduction
• Supports Trusted Send/Receive Security Protocol • Performance-tuned for seamless video applications • Built-in error recovery for non-stop video streaming • Best-in-class acoustic performance means virtually silent operation • Enhanced caching capabilities enable superior video recording quality. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 7: About The Serial Ata Interface
Shadow Register Block. All Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the “Serial ATA International Organization: Serial ATA Revision 3.0”. The specification can be downloaded from www.sata-io.org. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 8: Drive Specifications
Standby to ready (max) <6s Track-to-track seek time (typical) <1.0ms read; <1.2ms write Average seek (typical) <12.0ms Startup current (typical) 12V (peak) 1.6A Voltage tolerance (including noise) 5V: ± 5% 12V: ±10% Seagate Video 3.5 HDD Product Manual, Rev. B... - Page 9 **During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels Seagate Video 3.5 HDD Product Manual, Rev. B...
-
Page 10: Formatted Capacity
1745KBPI Track density (avg) 331ktracks/in Areal density (avg) 566Gb/in Spindle speed (RPM) 5900 ± 0.2% Internal data transfer rate (max) 1967Mb/s Sustained data transfer rate (max) 151MB/s I/O data-transfer rate (max) 600MB/s Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 11: Physical Characteristics
2.7 Start/stop times Start/stop times @ 25°C 1TB and 500GB model Power-on to ready (max) < 6.0s Standby to ready (max) < 6.0s Ready to spindle stop (max) 10.0s Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 12: Power Specifications
*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Measurement was taken in Idle 1 mode. †5W IDLE, Standby and Sleep, with DIPLM enabled Seagate Video 3.5 HDD Product Manual, Rev. B... - Page 13 Figure 1 Typical Current Profiles (12V) Seagate Video 3.5 HDD Product Manual, Rev. B...
- Page 14 Figure 2 Typical Current Profiles (5V) Seagate Video 3.5 HDD Product Manual, Rev. B...
-
Page 15: Conducted Noise
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all com- mands and returns to Active mode when disk access is necessary. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 16: Environmental Specifications
The nonoperating shock level that the drive can experience without incurring physical damage or degradation in performance when subsequently put into operation is 300 Gs (for 3TB and 2TB model) and 350 Gs (for 1TB) based on a nonrepetitive half-sine shock pulse of 2ms duration. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 17: Vibration
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 18: Electromagnetic Immunity
From this page, click on “Is my Drive under Warranty”. Users will be asked to provide the drive serial number, model number (or part number) and country of purchase. The system will display the warranty information for the drive. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 19: Agency Certification
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. -
Page 20: Environmental Protection
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. -
Page 21: Configuring And Mounting The Drive
For installations which require cables, users can connect the drive as illustrated in Figure 3 Figure 3 Attaching SATA cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Video 3.5 HDD drives support latching SATA connectors. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 22: Drive Mounting
Note. Image is for reference only, and may not represent actual drive. Figure 4 Mounting dimensions (1TB and 500GB models) Note. Image is for reference only, and may not represent actual drive. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 23: Serial Ata Interface
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate back- plane configuration. All used voltage pins (V ) must be terminated. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 24: Supported Ata Commands
Read DMA Without Retries Read FPDMA Queued Read Log Ext Read Multiple Read Multiple Extended Read Native Max Address Read Native Max Address Extended Read Sectors Read Stream DMA Extended Read Stream Extended Seagate Video 3.5 HDD Product Manual, Rev. B... - Page 25 / D1 S.M.A.R.T. Read Data / D0 S.M.A.R.T. Read Log Sector / D5 S.M.A.R.T. Return Status / DA S.M.A.R.T. Save Attribute Values / D3 S.M.A.R.T. Write Log Sector / D6 Standby Standby Immediate Seagate Video 3.5 HDD Product Manual, Rev. B...
- Page 26 Write FPDMA Queued Write Log Extended Write Multiple Write Multiple Extended Write Multiple FUA Extended Write Sectors Write Sectors Without Retries Write Sectors Extended Write Stream DMA Extended Write Stream Extended Write Uncorrectable Seagate Video 3.5 HDD Product Manual, Rev. B...
-
Page 27: Identify Device Command
Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Number of sectors transferred during a Read Multiple xxxx or Write Multiple command Seagate Video 3.5 HDD Product Manual, Rev. B... - Page 28 Enhanced security erase time 00A9 Master password revision code FFFE Hardware reset value xxxx Stream Min. Request Size 0000 Streaming Transfer Time - DMA 0000 Streaming Access Latency- DMA and PIO 0000 Seagate Video 3.5 HDD Product Manual, Rev. B...
- Page 29 SMART error login is supported. SMART self-test is supported. Media serial number is supported. Media Card Pass Through Command feature set is supported. Streaming feature set is supported. GPL feature set is supported. Seagate Video 3.5 HDD Product Manual, Rev. B...
- Page 30 Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Video 3.5 HDD Product Manual, Rev. B...
-
Page 31: Set Features Command
Disable use of SATA features. Enable read look-ahead (read cache) feature (default). Report full capacity available. At power-on, or after a hardware or software reset, the Note default values of the features are as indicated above. Seagate Video 3.5 HDD Product Manual, Rev. B... -
Page 32: Commands
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Video 3.5 HDD Product Manual, Rev. B... - Page 33 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100780435, Rev. B...