Seagate Elite ST43401N/ND Reference Manual page 43

ST43401N/ND and ST43402ND Reference Manual, Rev. C
continued from previous page
Byte 12 Byte 13 Description
17 02 Recovered data with positive head offset
17 03 Recovered data with negative head offset
17 05 Recovered data with previous sector ID
17 06 Recovered data without ECC—data auto-reallocated
18 00 Recovered data with error correction applied
18 01 Recovered data with error correction and retries applied
18 02 Recovered data with ECC and/or retries—data auto-reallocated
19 00 Defect list error
19 01 Defect list not available
19 02 Defect list error in primary list
19 03 Defect list error in grown list
1A 00 Parameter list length error
1B 00 Synchronous data transfer error
1C 00 Defect list not found
1C 01 Primary defect list not found
1C 02 Grown defect list not found
1D 00 Miscompare during verify operation
1E 00 Recovered ID with ECC correction
20 00 Invalid command operation code
21 00 Logical block address out of range
24 00 Invalid field in CDB—check field pointer in sense data
25 00 Logical unit not supported
26 00 Invalid field in parameter list—check field pointer in sense data
26 01 Parameter not supported—check field pointer in sense data
26 02 Parameter value invalid—check field pointer in sense data
26 03 Threshold parameters not supported
27 00 Write protected
28 00 Not ready to ready transition—medium may have changed
29 00 Power on, reset, or bus device reset occurred
29 00 Device reset message, bus reset (dual port only)
29 01 Power on, reset (dual port only)
2A 00 Parameters changed
2A 01 Mode parameters changed
2A 02 Log parameters changed
2B 00 Copy cannot execute since host cannot disconnect
2C 00 Command sequence error
continued
35