Table of Contents
Advertisement
❖
When I press the power button
Set this option to Standby to put the computer into
Standby mode when you press the power button.
❖
When I close the lid
Set this option to Standby to put the computer into
Standby mode when you close the display panel.
5
Click Override all Modes with settings here.
6
In the Set to range dialog box, click on one of these options:
❖
Click DC only to apply the settings only when you are
using battery power.
❖
Click All to apply the settings whether you are using
battery power or outlet power.
7
Click OK.
8
Click OK again, then close the Control Panel.
NOTE: For more information about the Power Saver utility,
see
"Toshiba Power Saver utility" on page
Starting again from Standby mode
To start up the computer from Standby mode, press the power
button until the on/off light changes to green. The computer
returns to the screen you were using.
If you put the computer in Standby mode by closing the display
panel, you can start it again by opening the display panel.
Learning the Basics
Powering down the computer
107
177.
Advertisement
Table of Contents
