Toro Groundsmaster 4300-D Operator's Manual page 15

InfoCenter Icon Description (cont'd.)
Start the engine.
The PTO is on.
The cruise control is on.
Shut off the engine
Engine
Key switch
Cutting units are lowering
Cutting units are raising
PIN code
Hydraulic fluid temperature
CAN bus
InfoCenter
Bad or failed
Center
Right
Left
Bulb
Output of TEC controller or control
wire in harness
Over the allowed range
Under the allowed range
Out of range
/
Switch
Operator must release switch
InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below
Accessible only by entering PIN
15
Operator should change to indicated
state
Operator should put machine in
neutral
Engine start is denied
Engine shutdown
Engine coolant is too hot
Hydraulic fluid is too hot
DPF ash accumulation notification.
Refer to Servicing the Diesel
Particulate Filter (DPF) in the
maintenance section for details
Reset-standby regeneration request
Parked or recovery regeneration
request
A parked or recovery regeneration is
processing.
High exhaust temperature
The power take-off is disabled.
Sit down or engage the parking
brake.