Battery Pack; Settings - Festool T18+3 Instructions Manual

English
8

Battery pack

8.1 Changing the battery pack
Inserting the battery pack [2a]
BP/C 18
Removing the battery pack [2b]
2
The battery pack is ready to use straight out of
the box and can be charged at any time.
8.2 Capacity indicator
The capacity display [1-3] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-2] is pressed:
12
2a
1
2b
70–100%
40–70%
Recommendation: Charge the battery pack
*
before any further use.
Further information about the battery pack
and charger can be found in the corre­
sponding operating manual.
9

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
9.1 Changing direction of rotation [1-6]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
9.2 Changing gear [1-8]
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
9.3 Fastening
Adjust the switch so that its marking [1-11]
faces the screw symbol [1-10].
Adjust the torque accordingly at the torque
wheel [1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-5] again to start the machine.
9.4 Drilling
Adjust the switch [1-11] so that its marking
faces the drilling symbol [1-9]. Maximum tor­
que is set in this position.
15–40%
< 15%
*