Closing The Display Panel; Caring For Your Computer - Toshiba P100-ST7211 User Manual

78
Getting Started

Caring for your computer

Configuring Standby mode options
You can place the computer into Standby mode by either
pressing the power button or closing the display panel. You
can also specify an amount of time after which the computer
automatically goes into Standby mode.
To use any of these methods, you first need to enable them in
the Power Options Properties window. For information on
configuring the power options, see
page 112.
Once the computer is configured, you can place it into
Standby mode by either pressing the power button or closing
the display panel, depending on the Standby options set.
Starting again from Standby mode
To start up the computer from Standby mode, press the power
button until the on/off light glows blue. The computer returns
to the screen(s) you were using.
If you place the computer in Standby mode by closing the
display panel, you can start it again by opening the display
panel.

Closing the display panel

After you have turned off the computer, close the display
panel to keep dust and dirt out of the computer.
Caring for your computer
This section gives tips on cleaning and moving your
computer. For information about taking care of your
computer's battery, see
power" on page
"Running the computer on battery
101.
"Power Schemes" on