Manual Switching Of C.o. Incoming Call Destination - NEC NEAX2400 IMX Features Manual

M-51
M-51 Manual Switching Of C.O. Incoming Call
General Description
This feature allows the Console operator to manually change the termination point of a specific group of trunks.
Trunks that normally are used as DIT trunks may be changed to terminate at the Console.
Operating Procedure
To change the termination of DIT trunks from stations to the Console:
•
Step
1 Press the CIC key.
Dial # and the tenant number (2-7); then press
2
ENTER.
3 Press EXIT.
To change the termination of trunks from the Console to the DIT station or Business Console:
•
Step
1 Press the CIC key.
Dial * and the tenant number (2-7); then press
2
ENTER.
3 Press EXIT.
Service Conditions
1. Only trunks in tenants 2-7 may be switched. The Console must be in tenant 1.
2. This service is only applicable to C.O. ring-down trunks.
3. It is possible to reverse the Console display through system programming so that trunks terminating to the
DIT stations will be displayed as Not Switched. Calls terminating to the Console will be displayed as
Switched.
4. Since CIC key is assigned in the same place as the AUD key, AUDIT REPORTS [A-26] function is not
available when this feature is activated.
5. This feature is not available across a CCIS network.
6. Check-In/Checkout or Check-In Cancellation will not change the destination of the DIT calls.
Page 112

Manual Switching Of C.O. Incoming Call Destination

Destination
Action
Action
The associated LED flashes.
The LED stays steadily lit.
The Console displays the status of the trunks as Not
Switched.
The associated LED flashes.
The LED stays solid.
The Console displays the status of the trunks as Not
Switched.
NEAX2400 IMX Hotel Features and Specifications
Result
Result
NDA-24245, Issue 2