Selection Of X1/Z1 And X2/Z2 Reports To Be Printed In The Stacked Report Sequence 2620 - Sharp ER-A420 Instruction Manual

FOR THE MANAGER-2-A410/A420
Selection of X1/Z1 and X2/Z2 reports to be printed in the stacked report
sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request.
Procedure
2620
1
*
Job no.
• Maximum 70 steps are programmable. "1 step" means the memory size used for one no-range
Note
type job no. The range type job no. needs "8 steps".
• When Z of stacked report is initiated, X only reports will be skipped.
Job code numbers to be used are as follows.
*1: Job no. Report name
00 General
10 Full department
13 Full department group
20 PLU
24 PLU stock
27 PLU zero sales
29 PLU price category
30 Transaction
31 Total in drawer
32 Commission sales
40 Full clerk
50 Full cashier
60 Hourly sales information
70 Daily net report
80 PBLU report
82 Balance report
*3: Both range setting and full setting are allowed.
Example
02.4.20 6:49 PM Page 77
2620
PGM 2
To cancel the stacked report sequence
For full reporting (non-range report)
2
*
Start range
parameter
To program for another Job no.
*2: Start/End range parameter
*3 Start PLU code/End PLU code (1 through 999999)
*3 Start PLU code/End PLU code (1 through 999999)
*3 Start price amount/End price amount
*3 Start time/End time (0 through 2330)
*3 Start PLU code/End PLU code (1 through 9999)
Key operation
2620
10
13
For individual reporting
2
*
End range
parameter
Range report is available
only in the X1 mode.
Print
Note
77