Job-Code-Based Programming; Setting The Date And Time; Setting The Date (#2610); Setting The Time (#2611) - Sharp ER-A420 Instruction Manual

FOR THE MANAGER-1-A410/A420

Job-Code-Based Programming

This section illustrates how to program items using job codes. Using job codes allows you to program a wide
variety of items in comparison with direct programming.
Start this programming by entering a corresponding job code as shown below.
.
2110
All the items which can be programmed by the job-code-based programming are listed on this page and the
following, and those which can also be programmed by the direct programming are marked with the symbol
" Direct " that follows job codes.

Setting the date and time

1
Setting the date
Enter day (one or two digits), month (two digits), and year (four digits) in this sequence.
Procedure
.
2610
Example
Setting the time
Set the time using the 24-hour format. For example, when the time is set to 2:30 AM, enter 230; and when it is
set to 2:30 PM, enter 1430.
Procedure
.
2611
02.4.20 6:48 PM Page 31
≈
2610 Direct
PGM 2
≈
Date (7 or 8 digits)
Key operation
. ≈
2610
;
26082003
2611 Direct
PGM 2
≈
Time (max. four digits)
;
Print
Date
;
31