Table of Contents
Advertisement
Self-test
Print the printer configuration after you run Gap/Black Mark Sensor calibration. The self-test
printout lists the printer's configuration and available memory, and can indicate if there is any
dot damage on the heater component.
Self-test printout
Model name
Firmware version
Firmware checksum
Printer serial number
Configuration file
System date
System time
Printed mileage (meter)
Cutting counter
Number of defective dots
Print speed (inch/sec)
Print density
Label size (inch)
Gap distance (inch)
Gap/Black Mark Sensor
sensitivity
Code page
Country code
Quality mode
Print darkness
Print speed (inch/sec)
Label size
Control prefix
Format prefix
Delimiter prefix
Printer power up motion
Print Head close motion
RS232 Serial Port
configuration
55
Advertisement
Table of Contents
