B&B Electronics 232XSSD4 Manual page 9

Figure 3. Master Port DCE/DTE Jumpers
Figure 4. PC Board Options for RS-485
If an IBM PC (DTE device) is connected to the 232XSSD4
Master port, the Master port should be configured as a DCE port. If
a modem (DCE device) is connected to the Master port, it should be
configured as a DTE port. Refer to cable charts in Appendix B.
The Master port is configured as either a DCE port or a DTE
port by moving jumpers JP1: 1 through JP1: 7. JP1 is located inside
the Smart Switch. Refer to Figures 2 & 3. To configure the Master
port as a DCE port, jumpers JP1: 1 through JP1: 7 must be moved
to the DCE position. Refer to Table 2. To configure the Master port
as a DTE port, jumpers JP1: 1 through JP1: 7 must be moved to the
DTE position. Refer to Table 3.
6
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
232XSSD43800 Manual