Parameters - B&B Electronics 232XSSD4 Manual

If the software was installed on your hard drive follow these
steps:
• Type C: and press the ENTER key.
• Type CD\XSS and press the ENTER key.
Or if you are going to execute XSSTSR.COM from the floppy drive
follow these steps:
• Place the "DOS" disk in drive A.
• Type A: and press the ENTER key.
To begin the XSSTSR program (the following will be used as an
example):
Port Address = 03F8
Baud = 9600
Data Bits = 8
• Type XSSTSR A03F8 B7 D8 P1 U8 C0 H4 and press the
ENTER key.
Using this method, every time you want to install the XSSTSR
with different parameter settings than the default (refer to the Default
Values section), the missing parameter must be specified.

Parameters

The Port Address is the address where the serial
communications port is located. If this is unknown you can use the
program PORTFIND.EXE which is located on the disk. To use
PORTFIND.EXE:
If you installed the software on your hard drive (see the
Installation section):
• Type C: and press the ENTER key.
• Type CD\XSS and press the ENTER key.
• Type PORTFIND and press the ENTER key.
24
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
Parity = Odd
User Defined Char. = 8
Command String = 0
Hot Key Sequence = 4
PH (815) 433-5100 -- FAX (815) 433-5104
232XSSD43800 Manual