Table of Contents
Advertisement
Hot Key Method
This method enables the user to select any Smart Switch port by
pressing a pre-defined sequence of keys at the same time after the
XSSTSR is installed (refer to Program Installation section).
Example:
If Hot Key sequence <Lft Shift><Alt><A|B|C|D|E|F|G|H|N> was
selected, to change ports you would press at the same time:
Left Shift - Alt - A...... to select port A
Left Shift - Alt - B ..... to select port B
Left Shift - Alt - C ..... to select port C
Left Shift - Alt - D ..... to select port D
Left Shift - Alt - E ..... to select port E
Left Shift - Alt - F ..... to select port F
Left Shift - Alt - G ..... to select port G
Left Shift - Alt - H ..... to select port H
Left Shift - Alt - N ..... to turn off all ports
Then press the address character to indicate the location of the
desired port. This character is not required when turning ports off.
Command Line Method
This method enables the user to select any Smart Switch port
through the command line. To specify a Smart Switch port through
the command line, you would type XSSTSR followed by the X
command symbol and the letter of the port.
232XSSD43800 Manual
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
27
Advertisement
Table of Contents
