Sign in today to find solutions:

Forgot your password?

Don't have an account? Sign up

ADT Security Services EZ Using Manual: System Trouble Error Codes

Adt home security system safewatch ez user guide.

   
Your ADT Safewatch EZ System is constantly monitoring its own components, as well as all critical services, such as AC power and
the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble occurs, the
EZ Touchpad will caution you with a Trouble TBL light and a beeping sounder.
If you cannot immediately fix the trouble, the system can still be used. Simply press SILENCE to view the trouble as described below
and press SILENCE again to exit the VIEW TROUBLE mode. The system can now be armed.
To view the trouble, press SILENCE, count the number of Trouble TBL and READY flashes and refer to the following table. If there
is more than one trouble to view, press SILENCE again to scroll to the next trouble, and again to exit the VIEW TROUBLE mode. The
Trouble TBL light will remain pulsing as a reminder if the trouble is still present. NOTE: If EZ Touchpad siren chirps once every 10 sec-
onds, call for service.
TBL
READY
Flashes /
Flashes
Touchpad beeps
STEADY
NONE
1
NONE
2
NONE
3
NONE
4
NONE
5
NONE

SYSTEM TROUBLE ERROR CODES

Trouble Condition
Zones Bypassed
This is a reminder that zones have been bypassed (by pressing
necessary to bypass any inoperative zones, it is important to have the zones re-
paired as soon as possible.
AC Power Failure
This trouble will occur if AC power is not present. Make sure the system trans-
former is plugged into its AC receptacle and check the circuit breaker, otherwise
call for service.
Low Battery
If there has been a recent power failure, the battery may be partially depleted and
must be recharged by the control panel. If the trouble does not clear in 24 hours,
call for service.
Communication
The system was not able to report to central station. If this is due to a temporary
Failure
interruption in the telephone service, the trouble can be cleared when the service
is restored by pressing
Telephone Line Cut
The telephone line has failed. If telephone service has been temporarily inter-
rupted, the trouble will clear when restored. Otherwise, call for service.
Bell/Siren Trouble
There is a problem with the Bell or Siren. Call for service.
Action
again.
SILENCE
). If it is
BYPASS
17

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: