Fire Protection - ADT EZ Using Manual

If a fire is detected, the siren will sound a distinct pulsating tone and the FIRE indicator on the EZ
Touchpad will be flashing. If a Fire Alarm does occur:
FIRE
*
Note: This feature may not apply to your system. Consult your installer to determine if your system includes fire protection.
1
If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone.
If there is no evidence of a fire, press
2
The siren will silence, and FIRE on the EZ Touchpad will stop flashing, and light steady.
Determine which device went into alarm. If you are protected by smoke detectors, the light on the
3
active detector will be lit. Once it is determined which smoke detector is in alarm, press
reset the smoke detector.
4 If the Fire Zone has reset properly, the FIRE light should go out in approximately 30 seconds. If it
FIRE
does not go out, press
Fire-Zone Trouble
The system is constantly monitoring the Fire Zone to insure the connections to the protective de-
vices are in good working order.
TBL
If a problem on a Fire Zone is detected, a System Trouble will display. The sounder will activate
and the Trouble TBL light will blink 7 times.
Press the
F I R E P R O T E C T I O N *
again in a few minutes. If it still does not go out, call for service.
SILENCE
button to silence the sounder. Call for service immediately.
SILENCE
OR insert your EZ-IFOB key into the EZ Touchpad.
SILENCE
to
SILENCE
15