Heating Your Room - Samsung PH28ZA1 Owner's Instructions Manual

Heating Your Room

You must select the Heat mode if you wish to adjust the:
Heating temperature
Fan speed when heating
1
If necessary, press the
Result: The POWER indicator on the indoor unit lights up.
The air conditioner starts up in the mode selected
when the unit was last used.
The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2 If the is not displayed at the top of the remote control,
press the MODE button on the remote control one or more times until it
appears.
Result: The indoor unit beeps each time you press the MODE button.
The air conditioner runs in HEAT mode.
N N o o t t e e You can change modes at any time.
N N o o t t e e
3 To adjust the temperature, press the TEMPERATURE buttons one or
more times until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result: Each time you press the TEMPERATURE buttons:
- The temperature is adjusted by 1°C
- The indoor unit beeps
The air conditioner starts heating, provided that the room
temperature is lower than the selected temperature;
the fan will, however, operate.
4
Select the fan speed by pressing the FAN button one or more times
until the required setting is displayed:
Automatic (rotated :
Low
Medium
High
Result: Each time you press the FAN button, the indoor unit beeps.
For the first 3 to 5 minutes, the fan does not operate until the
air has been sufficiently warmed. Once the correct temperature
has been reached, the fan will be automatically switched to the
selected speed.
5 To control the direction of the air flow, refer to pages 16 and 17.
(On/Off) button.
)
11
E-