PERATING ONDITIONER Cooling Your Room ... Airing Your Room ... Removing Excess Humidity ... 10 Adjusting the Air Flow Direction Horizontally ... 11 Adjusting the Air Flow Direction Vertically ... 11 ROGRAMMING ONDITIONER Setting the On Timer ... 12 Setting the Off Timer ... 13 Setting the Sleep Timer ...
The power plug contains a Reset button that will automatically shut down the air conditioner in the event of a power surge. To restart the unit, press the Reset button and the unit will return to normal operation in 2-3 minutes.
Batteries may be completely discharged after 12 months, even if they have not been used. Push the battery cover on the rear of the remote control with your thumb in the direction of the arrow and remove it. Insert the two batteries, taking care to respect the polarities : + on the battery with + on the remote control.
You must select the Cool mode if you wish to lower the temperature in your room. You can also set the Fan speed. Remote Control Control Panel It will begin to cool after three minutes is displayed. higher than the selected temperature,...
(On/Off) button. Result: The air conditioner starts up in the Cool mode. The unit beeps twice. If the fan speed(F1, F2 or F3) is not displayed on the control panel: Press the button on the remote control Press the button on the unit one or more times until the fan speed...
Removing Excess Humidity Remote Control Control Panel If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. If necessary, press the (On/Off) button. Result: The air conditioner starts up in the Cool mode.
Adjust the inner air flow blades to the desired position by sliding them side to side. The outer air flow blades can be adjusted to control the vertical air flow direction.
The fan will continue to run for a short time after the compressor cycles off. If you would like the air conditioner to run in Dry mode, do not press button. You cannot use the Dry mode in the energy saving E.Saver...
Do not, under any circumstances, cut or remove the third grounding prong from the power cord. We recommend that you do not use an extension cord or an adapter plug with this appliance. Do not change the plug on the power cord of this appliance.