Table of Contents
Advertisement
Heating Your Room
You must select the Heat mode if you wish to heat your room to a
specific temperature. You can also set the fan speed.
If necessary, press the
Result:
The operating mode indicator (COOL,FAN or HEAT) on the
unit comes on.
The air conditioner starts up in the mode selected when the
unit was last used.
The unit beeps twice.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
It will start up aotomatically after about three minutes.
If the HEAT indicator is not lit up on the unit:
Press the
button on the remote control
or
Press the MODE button on the unit one or more times until the HEAT
indicator lights up
Result:
The unit beeps each time you press MODE.
The air conditioner starts up in Heat mode.
You can change modes at any time.
3
To adjust the temperature, press the
control one or more times until the required temperature is displayed.
To adjust the temperature, press the
or more times until the required temperature is displayed.
Possible temperatures are between 8°C and 30°C inclusive.
Result:
Each time you press the temperaure buttons.
- The temperature is adjusted by °C and
displayed on the control panel
- The unit beeps
The air conditioner starts cooling if the room temperature
is higher than the selected temperature.
4
To set the fan speed to...
High
Med
Low
Result:
Each time you press a button, the unit beeps.
5
To control the direction of the air flow, refer to page .
DB98-22420A-1.indd
9
(On/Off) button.
or
button on the remote
or
button on the unit one
Then...
Press the
button on the remote control.
or
Press the
on the unit until the
indicator lights up
Press the
button on the remote control.
or
Press the
on the unit until the
indicator lights up
Press the
button on the remote control.
or
Press the
on the unit until the
indicator lights up
Remote Control
Control Panel
9
E-
2006-5-31
16:31:30
Advertisement
Table of Contents
