Service And Maintenance - Festool CTL 48 E LE EC/B22 Original Operating Manual

CTM 48 E LE EC/B22, CTL 48 E LE EC/B22
GB
CAUTION
Escaping foam and fluids

Switch off the machine immediately and empty
the dirt trap.
8.4 After finishing work
Empty the mobile dust extractor after every
use and clean if necessary.

Switch off the mobile dust extractor and pull out
the mains plug.

Wind up the mains power cable.

Empty the dirt trap.

Close off the extractor opening [1-2] using the
sealing plug [1-1].
WARNING
Hazardous dust
Damage to the respiratory passage

Wipe down the mobile dust extractor and clean
all accessories thoroughly using the extractor
(inside and out) before removing from the work-
ing area.

Parts that you were not able to clean thoroughly
must be sealed in an airtight plastic bag prior to
transportation.

Wear a dust mask!
The machine shall be stored indoors only.

Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
18
Observe the following instructions:
– A dust test must be performed at least once a
year by the manufacturer or an instructed per-
son. This test may include checks to determine
whether the filter is damaged, the machine is
sealed properly and the monitoring features are
functioning correctly.
– During maintenance and repair work, all compo-
nents that cannot be cleaned satisfactorily must
be replaced. The old components must be sealed
in impermeable plastic bags prior to disposal in
compliance with applicable regulations for this
type of waste.
– Provided maintenance personnel or other per-
sons in the vicinity are not endangered, the user
must dismantle and clean the machine prior to
performing maintenance work. Appropriate pre-
cautionary measures include decontaminating
the machine prior to disassembly, making provi-
sions for locally filtered forced ventilation at the
location of machine disassembly, cleaning the
maintenance area and appropriate personal pro-
tective equipment.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
EKAT Use only original Festool spare parts!
4
Order No. at:
5
3
2
1
9.1 Changing the filter element
NOTE
Motor damage

Never operate the extractor without a filter ele-
ment fitted as the motor may become damaged.

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Turn the top section of the machine so that the
main filter is facing upwards (Fig.[7]).

Fold over the lever [7-3] and remove the retain-
er. [7-2]

Remove the used main filter and replace [7-1]
with a new one.

Dispose of the used filter in accordance with
statutory regulations.