Table of Contents
Advertisement
Cleaning Your Smart Oven
The following parts of your smart oven should be cleaned regularly to
GB
prevent grease and food particles from building up:
•
Inside and outside surfaces
•
Door and door seals
•
Turntable and Roller rings
☛
ALWAYS ensure that the door seals are clean and the door closes
properly.
☛
Failure to maintain the oven in a clean condition could lead to
deterioration of the surface that could adversely affect the of the appliance
and possibly result in a hazardous situation.
1. Clean the outside surfaces with a soft cloth and warm, soapy water. Rinse and
dry.
2. Remove any splashes or stains on the inside surfaces or on the roller ring with a
soapy cloth. Rinse and dry.
3. To loosen hardened food particles and remove smells, place a cup of diluted
lemon juice on the turntable and heat for ten minutes at maximum power.
4. Wash the dishwasher-safe plate whenever necessary.
✉
DO NOT
spill water in the vents.
or chemical solvents. Take particular care when cleaning the door
seals to ensure that no particles:
•
Accumulate
•
Prevent the door from closing correctly
✉
Clean the smart oven cavity right ofter each use with a mild detergent
solution, but let the smart oven cool down before cleaning in order to
avoid injury.
✉
The instructions for cooking ranges, hobs and ovens shall state that a
steam cleaner is not to be used.
Installation & Wiring Instructions
IMPORTANT NOTE :
The mains lead on this equipment is supplied with a mouldedplug incorporating a fuse.
The value of the fuse is indicated on the pin face of the plug and, if it requires replacing,
a fuse approved to BS1363 of the same rating must be used.
Never use the plug with the fuse cover omitted if the cover is detachable. If a
replacement fuse cover is required, it must be of the same colour as the pin face of the
plug.
✉
Replacement covers are available from your Dealer. If the fitted plug
is not suitable for the power points in your house or the cable is not
long enough to reach a power point, you should obtain a suitable
safety approved extension lead or consult your Dealer for assistance.
However, if there is no alternative to cutting off the plug, remove the
fuse and then safely dispose of the plug. Do not connect the plug to a
mains socket, as there is a risk of shock hazard from the bared flexible
cord.
NEVER
use any abrasive products
Wiring Instructions
WARNING THIS APPLIANCE MUST BE EARTHED.
This appliance must be earthed. In the event of an electrical short circuit, earthing
reduces the risk of electric shock providing an escape wire for the electric current. The
appliance is equipped with a mains lead which includes an earth wire for connecting to
the earth terminal of your mains plug. The plug must be plugged into a socket that is
properly installed and earthed.
☛
The wires in this mains lead are coloured in accordance with the following
code:
•
Green-and yellow
•
Blue
•
Brown
◆ As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings indentifying the terminals in your plug,
proceed as follows.
◆ Connect the green-and yellow wire to the terminal in the plug marked with the
letter E or the earth symbol ( ) or coloured green or green-and-yellow.
◆ Connect the blue wire to the terminal marked with the letter N or coloured
black.
☛
Consult a qualified electrician or service technician if in doubt about any of
these instructions.
The manufacturer of this oven will not accept any liability for damage
to persons or material for non observance of these requirements.
There are no user+serviceable parts inside the oven and if the mains
lead of this appliance is damaged, it must only be replaced by
qualified service personnel approved by the manufacturer because
special tools are required.
WARNING
Ensure that the plug and power cord are not damaged
before use.
If you have any reason to remove the moulded plug from
this appliance, immediately remove the fuse and dispose
of the plug.
Do not connect the plug to a mains socket under any
circumstances as there is a danger of electric shock.
CIRCUITS
Your smart oven should be operated on a separate
circuit from other appliances. Failure to do this may
cause the circuit breaker to trip, the fuse to blow, or the
food to cook more slowly.
26
: Earth
: Neutral
: Live
Hide quick links:
Advertisement
Table of Contents
