Environment; Levelling; Connecting The Water Supply Hose - Samsung WA10V5WEP/XSG User Manual

installation & maintenance
The User's Manual is for common use. Make use of the User's Manual depending upon your washing
machine model.

ENVIRONMENT

Leave some space - Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface. - If the washer is placed on an uneven or weak surface, noise or
vibration occurs. (Allowable is 1°) Adjust the legs for even placement.
Never install the washer near water. - Do not place the washer in steamy rooms or where the washer is
directly exposed to rain. Moisture may destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters. - As plastic an electrical components are affected by direct heat, never
place the washer near furnaces, boilers, etc. Do not place under direct sunlight.

LEVELLING

If the washer is not leveled with the ground, it makes the machine tremble more or be out of order.
So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
• Open the lid of the machine, pour water into the tub up to the level
just below the pulsator, and adjust the legs so that the pulsator is
positioned at the center of the water as shown in the figure.
•
Place the machine more than 10 cm away from the wall.
• Adjust the legs on feet for levelling.

CONNECTING THE WATER SUPPLY HOSE

1.
Remove the adaptor from the
water supply hose.
2.
First, using a "+" type screw
driver, loosen the four screws
on the adaptor. Next, take the
adaptor and turn part(b) following
the arrow for gap about 5 mm
between them.
3. Connect adaptor to the water tap
by tightening the screws firmly.
Then, turn part(b) following the
arrow and put (a) and (b) together.
• If the water tap is a screw type, assemble a water supply hose that fits to the tap as
shown. After completing connection, if water leaks from the hose, then repeat the same
steps.
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big,
remove the spacing ring before inserting the faucet into the adaptor.
WA10V5-02596H_EN.indd 11
c
a
5 mm
b
a
b
Water
LOOSEN
4.
Connect the water supply hose to
the adaptor. Pull down the part (c)
of the water supply hose. When
the part (c) is released, the hose
is automatically connected to the
adaptor making a 'click' sound.
5.
Connect the other end of the
water supply hose to the inlet
water valve at the back of the
washer. Screw the hose clockwise
all the way in.
5-1. Connect the other end of the
water supply hose to the inlet
water valve at the top of the
washer. Screw the hose clockwise
all the way in.
installation & maintenance_11
2009-03-20 ¿ÀÈÄ 2:38:45
LOCK