How To Connect The Drain Hose; How To Clean Pump Filter - Samsung WA10V5WEP/XSG User Manual

installation & maintenance

HOW TO CONNECT THE DRAIN HOSE

IN CASE OF PUMP-DRAINED WASHER
Take out the cap-hose and connect the outlethose.
Be sure to join tightly the drain hose into the
drainoutlet on the side of the machine.
HOW TO CONNECT THE DRAIN HOSE
CAUTIONS WHEN INSERTING THE DRAIN HOSE(IN CASE OF GENERAL WASHER)
Less than 3 m
1. Don't exceed more than 3m when the drain
hose is used by connecting with other hoses.
Less than 3 m
3. The doorsill shoudn't be more than 5 cm.
HOW TO CLEAN THE PUMP FILTER
1.
Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in position.
12_installation & maintenance
WA10V5-02596H_EN.indd 12
Be sure to join tightly the drain hose into the
drainoutlet on the back of the machine.
Install the drain hose in the position of about
90~100cm above the ground.
2. Be careful to drain water out at the end of the
drain hose.
Less than
5 cm
4. Don't install the drain hose underneath the
wash machine.
REAR SIDE
OPEN
CLOSE
FILTER
RAG
2009-03-20 ¿ÀÈÄ 2:38:46