Regency TTRC4824 Quick Manual

Rectangle and Corner Training table with T-Base
Organize your parts. You will need a phillips head screw driver, pencil and measuring tape, drill(optional).
A
Step 1: (E)
Screw 4 feet into
leg ends (G)
T-base .
STEP 4:
Next place the cylinder
(C)
over the exposed metal rod
(TTRC4824, TTRC6024, TTRC7224, TTCNR24, MTBT22)
Two people are required for assembly.
B C
D
Step 2:
On the rod
the nut from the bolt, set the nut
aside.
STEP 5:
Place the exposed end of
the metal rod (B) through the hole in
the spider (F) and twist the nut back
onto the rod until tight. Make sure the
front and back arms of the spider are
angled in the same direction as the
T-Base arms.
E F G
(B)
Step 3: Insert the rod (B) through the
remove
hole in the T-base (G).
The permanent
nut should be
on the underside
of (G).
A. Table Top
B. Rod
C. Cylinder
D. Screws (16)
E. Feet (4)
F. Spider
G. T-base
The product
should now
look like the
example to the
right.