Removing Convection Heater Element R14; Convection Thermostat Removal; Removing The Pt1000 Temperature Sensor (1R30) - Miele H 408 BM Series Technical Information

Technical Information
Note:
After installation of the fan rear panel, replace the bottom insulation strip.
Danger!
After installation is completed, as a matter of standard practice, check the
oven for a tight seal with a microwave leak detector, paying particular attention
to the door and the housing edges.
4.3

Removing Convection Heater Element R14

1. Remove the appliance from its cabinet (refer to Section 011-4.3).
2. Remove the three T20 screws securing the back wall, as well as the T20
screw securing the terminal block cover. Remove the terminal block cover
and the back wall.
3. Disconnect the connections from the convection heater (Figure 032-6,
Item 1), thermostat (Figure 032-6, Item 2) and convection fan (Figure
032-6, Item 3).
4. Remove the two T20 screws securing the sides of the fan rear panel
(Figure 032-6, Item 4).
5. Remove the bottom insulation strip.
6. Remove the four T20 screws securing the bottom of the fan rear panel
(Figure 032-6, Item 4).
7. Remove the fan rear panel with convection fan and convection heater.
8. Unscrew the heater element retaining nuts.
9. Remove the convection heater element.
Note:
After installation of the fan rear panel, replace the bottom insulation strip.
Danger!
After installation is completed, as a matter of standard practice, check the
oven for a tight seal with a microwave leak detector, paying particular attention
to the door and the housing edges.
4.4

Convection Thermostat Removal

Remove the two screws securing the thermostat. Unclip the thermostat and
remove it from its retaining bracket.
4.5

Removing the PT1000 Temperature Sensor (1R30)

1. Remove the appliance from its cabinet (refer to Section 011-4.3).
2. Remove the screws securing the left side of the lid.
3. Remove the screws securing the left side wall.
4. Remove the left side wall.
5. Push in on the notches of the temperature sensor retainer and gently
twist it out to remove.
56
H 408x BM