Appliance Removal (From A Cabinet); Outer Side Cover Removal; Side Panel Removal; Removing The Door Lock Torsion Spring - Miele H 408 BM Series Technical Information

Technical Information
Important!
New ovens may have a slight odor during the first use. To eliminate the
odor, the oven should be operated at a high temperature for 2 hours.
Before heating the oven, remove all accessories and labels from the oven
and ensure that the room is well ventilated during this process.
7. Touch the On/Off touchpad.
8. Select the "Bake" function.
9. Select "Convection Bake".
10. Select "Temperature".
11. Set the temperature to 435 °F (225 °C) using the keypad.
12. Select "Duration".
13. Set the duration to two hours by entering "2", "0", "0" using the numeric
keypad.
14. Touch the OK touchpad. The oven will run for 2 hours; the remaining time
appears in the display.
4.3

Appliance Removal (From a Cabinet)

1. Open the door.
2. Take all items out of the oven cavity.
3. Remove the screws securing the appliance to the cabinet (see Figure 011-2).
4. Lift the appliance out of the cabinet.
5. Disconnect the power cable.
4.4

Outer Side Cover Removal

1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the four T20 screws securing each side cover. Remove the side covers.
4.5

Side Panel Removal

1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the outer side covers. See Section 011-4.4.
3. Remove the five T20 screws securing the left side panel (3 on bottom, 2
on top). Remove the left panel.
4. On the right side panel, remove the T20 screws securing the high-voltage
capacitor and diode. Lay the capacitor on its side, inside the appliance, to
reduce strain on the diode wires.
5. Remove the five remaining T20 screws securing the right side panel (3 on
bottom, 2 on top). Remove the right panel.
4.6

Removing the Door Lock Torsion Spring

1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the screws securing the appliance lid. Remove the lid.
Danger!
Before performing any service or repair work, discharge the high-voltage
capacitor. See Section A-2.
3. Open the door.
4. Push the door latch up and hold (Figure 011-3, Item 1).
18
H 408x BM