Tuning Your Television For The Dvd-Vcr; Deck Control Keys - Samsung SV-DVD1 Instruction Manual

01722A SV-DVD1E/XEU-GB1 9/3/02 10:36 PM

Tuning Your Television for the DVD-VCR

GB
You must tune your television for the DVD-VCR only if you are not
using a Scart cable
STANDBY/ON OPEN/CLOSE
TRK- ATR TRK+
2
SHUTTLE
VOLUME PROG
S S
4
REC FRAME/STEP
14
Page 14
To view pictures from your DVD-VCR when a Scart cable
is used, the television must be set to the audio/video
mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON on the front of
the DVD-VCR or STANDBY/ON on the remote control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press ❿ II
5
Start a scan on your television or set the television to UHF
channel 60.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 19 and Problems and Solutions on page
65).
8
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result: That programme is now reserved for use with your
DVD-VCR.

Deck Control Keys

The DVD-VCR uses one set of controls to operate both decks. The
following keys are helpful in successfully controlling each deck.
1
STANDBY/ON Button
Press the STANDBY/ON button on the remote control or front
panel to turn on the DVD-VCR.
2
DVD Button
Press the DVD button on the remote control when you want to
control the DVD deck.
The DVD indicator will light on the Front Panel Display to show
that the DVD deck is selected.
3
VCR Button
Press the VCR button on remote control when you want to control
the VCR deck.
button. The VCR indicator will light on the Front Panel Display to show
that VHS deck is selected.
4
DVD-VCR Toggle
Press the SELECT button on the front panel to toggle control
between the DVD deck and the VCR deck.
5
The TV VIEW Key
Press the TV VIEW key repeatedly to cycle through all of your
input sources, including the DVD, VCR, Tuner (PR##), AV1, AV2
and AUX.
Before using the VCR operation of 14~44 pages, press
the VCR button on the remote control to select VCR
mode.
Before using the DVD operation of 45~63 pages, press
the TV VIEW button on the remote control to select and
watch DVD.
GB
STANDBY/ON
STANDBY/ON
TRK- AT
PHONES
1
1
SHU
VOLUME
3D SOUND A.DUB TV/VCR
DVD TV VIEW VCR
2 3
REC FRAME/STEP
LEVEL OPEN/CLOSE
DVD VCR
SELECT
4
MUTE LAST PR
3D SOUND A.DUB TV/VCR
DVD TV VIEW VCR
5
REC FRAME/STEP
15