Toro Groundsmaster 7200 Series Operator's Manual page 40

Figure 97
1. Deck-lift cylinder
2. Retaining ring
10. Remove the screw securing the front cylinder pivot pin
to the mower frame
11. Remove the cable tie securing the pressure and tank
hoses.
12. Remove the front pivot pin and slide the cylinder off
the rear pin (Figure
Note: Let the cylinder hang out of the way on the
hoses.
13. Pivot open the floor plate
the prop rod.
Figure 98
1. Floor plate
14. Remove the roll pin and loosen the 2 capscrews
securing the drive shaft to the gearbox shaft
3. Screw
4. Cylinder pin
(Figure 97).
97).
(Figure 98) and secure with
(Figure
1. Drive shaft
2. Gear box
15. Slide the drive shaft off the gearbox shaft.
16. Disconnect the tank hose from the control valve
(Figure 100).
2
1. Control valve
2. Tank hose
17. Cap the hose and fitting with a cap and plug.
18. Pull the tank hose back toward the rear of the frame.
99). 19. Disconnect the pressure hose from the control valve
(Figure 100).
20. Cap the hose and fitting with a cap and plug.
21. Pull the hose back toward the rear of the frame.
22. Lower the floor jack until the deck vertical support
assemblies are supporting the rear of the deck frame
and the rear bumper is lightly supported.
23. Carefully remove the bolts (3/4 inch), washers and nuts
that secure the deck frame to the rear frame (3 on the
left side and 2 on the right side)
40
Figure 99
3. Roll pin
4. Yoke
1
g028363
3
Figure 100
3. Pressure hose
(Figure 101).