Connecting The Network Cable; Affixing The Labels; Network Setting - Konica Minolta bizhub 4752 Installation Manual

19. Connecting the network cable

(1) Connect the main body and networking equip-
ment (HUB) using the network cable.
Note:
The following shows the recommended network
cables that correspond to each communication
speed.
• 10BaseT/100BaseTX: Category 5
• 1000BaseT: Category 5E, Category 6
Networkport
LED1
LED2
(2) Check LEDs for lighting conditions.
LED1:
Should light up steadily if the link network con-
nection has been made.
LED2:
Should blink according to the communications
status of the ACT network.

20. Network setting

Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
(1) Select the function to be used as follows:
Menu Utility Administrator Settings
the Administrator Password
TCP/IP Settings
(2) Touch "Manual Input" of IP Application Method
and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
(3) Touch "OK."
(4) Touch "OK" after the "TCP/IP Settings" screen is
displayed.
(5) Select the function to be used as follows:
Forward Detail Settings
tion, and make the operation check of TCP/IP.
Enter
Network Settings
IPv4 Settings.
PING Confirma-
21. Confirming the copy sample
After completing all the steps, take a sample copy
and confirm the image. If image troubles occur, first
turn OFF and ON the Main Power Switch, and then
redo the steps from E-7 "12. Date & Time Setting/
Time Zone Setting (Service Mode)" to E-7 "14. Unit
change."

22. Affixing the labels

Affix the supplied panel sheet to the surface of the
operation panel.
Note:
• The panel sheet is affixed on customer request.
• The panel sheet must be kept by the customer.
E-9