Programming Kill/Stun/Revive In 5-Tone - Icom IC-910H Programming Manual

Programming Kill/Stun/Revive in 5-Tone

This procedure enables you to kill or stun a selected radio. Revive is also available on some models. A stunned
radio can be revived by cycling power and entering a password; a killed radio must be re-cloned to be revived.
The following instructions assume that frequencies, tones, and squelch are set and the radios are in PMR mode
(found in the Menu bar under Model). Additionally, the Auto Reset Timer must be enabled (Memory CH) and a
value entered (Common -> Common). These instructions apply to all Icom radios with PMR capability.
TX radio
Memory Ch
Field
CH Mute
5Tone Signaling » Form
5Tone Signaling » STN
TX Code CH (under 5 Tone):
Field
Line 1 » Text
Lines 2, 3 etc. » Text
Unused lines » Sel
Key and Display (under Common)
Field
Key » P0-P3
© June 2011 Icom America
Setting / Description
Mute options depend on radio model:
Cont (not muted)
Or (not muted)
Set to EIA
st
Set to 1. Points to 1
Radio's 5 Tone code.
Setting / Description
Enter text for target radios, such as Kill or Stun Unit XXX
Enter text for any additional target radios
Set all unused lines to OFF so that you don't have to scroll
through them when selecting a Code.
Setting / Description
Assign a key (right-click Conventional field to access
menu) for the following functions:
TX Code CH Select— Enters the Code Select mode so
that you can select a target radio from the TX Code
Channel list.
TX Code CH Up—Allows you to scroll through the target
radio list and select a radio. (As an alternative, you can
also use the Up/Down keys to scroll.)
Call—Sends the 5-tone signal and Kill/Stun command to the
target radio.
line in the TX Code CH window: target
11