Sharp MX-2314N Service Manual page 167

Mode
Set value
Single
0 OFF
1 OFF
2 ON
3 ON
4 OFF
5 OFF
6 ON
7 ON
(*3)
Target
paper
Inner Postcard, The operation is stopped when
finisher envelope 10 sheets of a same kind are
discharged continuously. When,
however, different kinds of
sheets are mixed and
discharged and 10 or less
sheets of a kind are
continuously discharged, the
operation is stopped by the
paper exit tray full detection.
Label The operation is stopped when
sheet, 100 sheets of a same kind are
tab sheet, discharged continuously. When,
OHP however, different kinds of
sheets are mixed and
discharged and 100 or less
sheets of a kind are
continuously discharged, the
operation is stopped by the
paper exit tray full detection.
26-51
Purpose Setting
Function (Purpose) Used to set the specifications of the serial
port operation. (For PCI)
Section
Operation/Procedure
1) Enter the set value with 10-key.
When the PCI is installed, setting is made to 1 or 2.
2) Press [OK] key.
Item/Display Content
A PCI Serial port PCI mode OFF
SETTING (For connecting the serial
port vendor)
Serial port PCI mode ON
(JOB status LED: MODE1)
Serial port PCI mode ON
(JOB status LED: MODE2)
MODE1: Red LED is light/blink/OFF, MODE2: Red LED always
OFF
When "PCI SETTING" is changed from "0" to "1" or "2," if SIM26-03
"OUTSIDE AUDITOR" is set to "S_VENDOR," "OUTSIDE AUDI-
TOR" is changed to "NONE."
2-Color/Single
2-color Counter
OFF OFF
ON OFF
OFF OFF
ON OFF
OFF ON
ON ON
OFF ON
ON ON
Target paper setting
0 1
If it is set to "1,"
the operation is
stopped when
the paper exit
tray is full or
when 250
sheets
(35.5mm thick)
are discharged.
Setting Default
range value
0 0
(Serial
port PCI
mode
OFF)
MX-3114N SIMULATION 6 – 34
26-52
Purpose Setting
Function (Purpose) Used to set whether non-printed paper
(insertion paper, cover paper) is counted up
or not.
Section
Operation/Procedure
1) Enter the set value with 10-key.
0 Count up
1 No count up
2) Press [OK] key.
The set value in step 1) is saved.
Destination
U.S.A 0 (Counted)
CANADA 0 (Counted)
INCH 0 (Counted)
JAPAN 1 (Not counted)
AB_B 0 (Counted)
EUROPE 0 (Counted)
U.K. 0 (Counted)
AUS. 1 (Not counted)
AB_A 0 (Counted)
CHINA 0 (Counted)
26-53
Purpose Setting
Function (Purpose) User auto color calibration (color balance
adjustment) Inhibit/Allow setting.
Section
Operation/Procedure
1) Enter the set value with 10-key.
Item/Display Content
A COPY Copy
(1:YES 0:NO) mode
B PRINTER Printer
(1:YES 0:NO) mode
2) Press [OK] key.
The set value in step 1) is saved.
26-65
Purpose Setting
Function (Purpose) Used to set the finisher alarm mode.
Section
Operation/Procedure
Use the touch key to set.
Set
Item Content
value
LIMIT ON Number of
COPIES sets of
stapling:
Max. 50 sets
OFF Number of
sets of
stapling:
Not Limited
Default
Setting Default
range value
Allow 1 1
Inhibit 0
Allow 1 1
Inhibit 0
Setting Default
NOTE
range value
ON or ON
OFF