Blaupunkt PA Series Owner's Manual page 7

Power connection
Please check if the power source correspond to the rating voltage spec, which locates on the panel of unit. If it does not
matching, please consult to your dealer or service center.
Insert the female terminal of power cord into the AC outlet, and then connect the power plug with the wall-mount socket in
order to get the power source. Then switch on the main power button to turn on the display screen, which means the power
connection is succeed now.
Remote control battery installation
Open up the battery door and insert 2 x AAA dry battery into the compartment; please make sure the polarity of battery will
aim and correspond to the positive and negative silkscreen-printed symbol in the compartment. Then close the battery door.
Notes:
a. The best working distance of remote control is within 5 meters without any obstacle in between. Please aim to the remote
control sensor locates on the front of unit during operation.
b. The sensitivity of remote control will become weak when the battery power exhausted. Please replace it with fresh one for
operation.
c. Please take out the battery in case of none-operation in a long time.
d. Please dispose the battery in an environment friendly way. Please reference the local government requirement for the
detail.
General operation
1. Power on/off: switch the main power button on the panel can turn on or off the unit; you also can get standby on/off by
press power button from remote control.
2. Play source selection：press the MODE button on the control panel or remote control can switch the play source between
FM/Bluetooth/Line in/USB/SD in cycle.
3. Volume adjustment: Turn the main volume knob on the panel can increase or decrease the main output volume level. You
can also adjust the volume in small step by press the VOL +/- button from remote control, but the remote control adjusted max
volume level is limited by main volume setting level.
4. Treble & bass adjustment: Turn the treble/bass knob on the panel can adjust the output sound level.
5. Sound silence: press the MUTE from remote control can make the sound in silence; press it again to resume the sound
output.
6. Preset EQ: Press the EQ button from remote control can switch the EQ between Normal ,Rock, POP, Classic, Jazz, News.(
Function only available in USB/SD and Bluetooth mode)
7. Play/pause: press the button to pause the music, and press it again to resume the playback in Bluetooth/USB/SD mode.
8. Repeat: press the button to switch the music playback in repeat one/random/repeat all mode.
9. Power and overload: The power LED indicator will light on when the power connection is successful. The clip red color LED
will flare in case of overload and detected. This occurs is in order to protect your speaker. Please reduce the volume level in
order to prevent serious damage to speaker. (Power clip indicator only available in PA serie
5