Bypass Tray Pcb - Ricoh BY5020 Field Service Manual

1.Replacement and Adjustment
4.
Remove the solenoid.
Re-installation

When re-installing the solenoid, make sure that the arm of the solenoid is positioned above and in
contact with the plate of the pick-up roller shaft below.

To confirm correct installation, manually move the solenoid plunger to the left and right. When the
solenoid plunger is moved, the pick-up roller should move up and down smoothly.

Bypass Tray PCB

1.
Remove the rear cover.
2.
Disconnect the connectors on the board.
3. Remove the board.
Two rivets secure the lower edge of the board.
24
(Rear Cover)