Section 3 Installation; Sensor Preparation - Hach ORBISPHERE GA2 00 Series User Manual

O2 ec sensor
Hide thumbs Also See for ORBISPHERE GA2 00 Series:
Table of Contents

Advertisement

being used once. Refer to the documentattion supplied with the recharge kit for instructions on how
to use the anode cleaning tool for a GA2X00 sensor or for a A110X sensor.
The cotton washers provide additional protection against the formation of deposits and residue on
the center electrode and anode, which prolongs the time period required between sensor
maintenance.
The silicone discs are required for measurements in ultra-pure water or water containing ammonia.
®
The Dacron
mesh patches provide protection to the membrane when using a protection cap with a
grille.

Section 3 Installation

Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.

3.1 Sensor preparation

Chemical exposure hazard. Obey laboratory safety procedures and wear all of the personal
protective equipment appropriate to the chemicals that are handled. Refer to the current safety data
sheets (MSDS/SDS) for safety protocols.
Your sensor has been thoroughly cleaned and tested at the factory before shipment. It has been
shipped with a cartridge containing a membrane and electrolyte pre-installed to protect the sensor
head. This cartridge must be removed and replaced with a new one prior to first use to make it fully
operational. The new cartridge is included in the sensor recharge kit.
• Non-ATEX sensors (GA2400). The sensor has been delivered with two protection caps, one with
a grille and one without. Ensure you use the correct protection cap for your application. Refer to
Sensor configurations
• ATEX sensors (GA2800). The sensor has been delivered with a single protection cap.
The following instructions detail the steps required to make the sensor operational.
Note: It is advisable to perform this procedure with the plastic sensor base installed so as to avoid any damage to
the connection socket and also to provide a suitable stand for the sensor when required.
10 English
C A U T I O N
C A U T I O N
on page 4 for additional information.

Advertisement

Table of Contents
loading

Table of Contents