Control Cabinet Installation For Devices In The Chassis-2 Format; Mounting Aid For Active Line Modules Chassis-2 And Motor Modules Chassis-2 - Siemens SINAMICS S120 Manual

Cabinet design and EMC

9.4 Control cabinet installation for devices in the Chassis-2 format

Article number 6SL3321-
Cooling air [m³/s]
requirement
Min. opening
cross-section in
cabinet inlet
outlet
[m²]
[m²]
9.4 Control cabinet installation for devices in the Chassis-2 format
9.4.1 Mounting aid for Active Line Modules Chassis-2 and Motor Modules
Chassis-2
Mounting aid
The mounting aid is used to install and remove the Active Line Modules Chassis-2 and Motor
Modules Chassis-2 in a Rittal VX25 or TS8 control cabinet.
The mounting aid is placed in front of the control cabinet and fastened to the upper side of
the control cabinet. The rails can be adapted to the installation height of the power unit to
facilitate horizontal installation and removal.
During installation, the crossbar of the mounting aid is attached to the crane lifting lugs
provided on the power unit. This prevents the power unit from toppling over and rolling
away.
The power unit is lifted and lowered using the integrated cable winch.
434
Motor Modules Chassis-2
1TE36-6AA0
1TE37-4AA0
1TE38-1AA0
1TE38-8AA0
1TE41-0AA0
1TE41-1AA0
1TE41-2AA0
1TE41-3AA0
1TE41-5AA0
0.64
0.38
0.28
Air-cooled chassis power units
Equipment Manual, 06/2020, 6SL3097-5AE00-0BP3