Changing The Management Port Configuration - Fluke OptiView T1/E1 Getting Started Manual

OptiView
Getting Started Guide

Changing the Management Port Configuration

Previously, when you set up the analyzer (under "Setting Up the
Analyzer"), you statically assigned the
through the serial configuration port. If you want to change that
configuration now or use a DHCP-assigned IP address, complete the
following:
1. Click
2. In the
•
•
3. Click
This warning is displayed: Connection to remote OptiView
analyzer may be lost. Proceed anyway?
4. Click
If you lose the remote connection to the analyzer because you
changed the IP address, you can reconnect through the
Browser
44
Management Port
TCP/IP Settings
To use a DHCP-assigned address, check the
box.
settings
OR
To use a static IP address, select or type IP address information
in the ,
Source Mask
fields.
Secondary DNS
to apply the changes.
.
as described under "Starting the Remote User Interface".
MANAGEMENT
.
section:
, ,
Router Primary DNS
port's IP address
Use DHCP to acquire
, or (optional)
OptiView